Durango 4WD V8-5.9L VIN Z (1998)
Separator Plate Filter Screen Installation
2. Install filter screen in upper housing separator plate.
Brace Plate
3. Align and position upper housing separator plate on transfer plate.
4. Install brace plate. Tighten brace attaching screws to4 Nm (35 inch lbs.) torque.
5. Install remaining separator plate attaching screws. Tighten screws to 4 Nm (35 inch lbs.) torque.
UPPER AND LOWER HOUSING
Check Ball Locations In Upper Housing
1. Position upper housing so internal passages and check ball seats are facing upward. Then install check balls in housing. Eight check balls are used.
The single large check ball is approximately 8.7 mm (11/3,2 inch) diameter. The single small check ball is approximately 4.8 mm (3/16 inch) in
diameter. The remaining 6 check balls are approximately 6.3 mm (1/4 inch) in diameter.