Durango 4WD V8-5.9L VIN Z (1998)
Governor Pressure Solenoid
5. Install governor pressure solenoid in governor body. Push solenoid in until it snaps into place in body.
Governor Body And Gasket
6. Position governor body gasket on transfer plate.
Pressure Solenoid Retainer
7. Install retainer plate on governor body and around solenoid. Be sure solenoid connector is positioned in retainer cutout.
8. Align screw holes in governor body and transfer plate. Then install and tighten governor body screws to 4 Nm (35 inch lbs.) torque.