Durango 4WD V8-5.9L VIN Z (1998)
NOTE: The bearing rotating torque should be constant during a complete revolution of the pinion. If the rotating torque varies, this indicates a
binding condition.
12. The seal replacement is unacceptable if the final pinion nut torque is less than 285 Nm (210 ft. lbs.).
13. Install the propeller shaft with the installation reference marks aligned.
14. Tighten the universal joint yoke clamp screws to 19 Nm (14 ft. lbs.).
15. Install the brake drums.
16. Install wheel and tire assemblies and lower the vehicle.
17. Check the differential housing lubricant level.
