Durango 4WD V8-5.9L VIN Z (1998)
Remove Bearing From Yoke
6. Grasp the protruding bearing by vise jaws. Tap the link yoke with a mallet and drift to dislodge the bearing cap from the yoke.
Remove Center Kit
7. Flip assembly and repeat Step 4, Step 5, and Step 6 to, remove the opposite bearing cap. This will then allow removal of the cross centering kit
assembly and spring.
8. Press the remaining bearing caps out the other end of the link yoke as described above to complete the disassembly.
ASSEMBLY
During assembly, ensure that the alignment marks on the link yoke and propeller shaft yoke are aligned.
1. Apply extreme pressure (EP) N.L.G.I. Grade 1 or 2 grease to inside of yoke bores to aid in installation.
