Durango 4WD V8-5.9L VIN Z (1998)
Inner C/V Joint Boot
6. Position the large-diameter end of the inner C/V joint boot over the edge of the housing. Insert the lip of the boot into the locating groove at the
edge of the housing.
7. Insert the small lip into the locating groove in the interconnecting shaft.
8. Retain the small-diameter of the boot on the shaft with a ladder-type clamp in the boot groove. Verify that the boot and lip are properly positioned
on the intermediate shaft. Position the clamp locating tabs in the slots and tighten the clamp.
Compressing Clamp Bridge
9. Compress the clamp bridge with Remover/Installer C-4124. Squeeze the tool handles to complete the tightening of the clamp. Care must be
exercised when using the tool to avoid cutting through the clamp bridge or damaging the boot.
10. Position the large-diameter end of the boot on the C/V joint housing.
11. After the inner joint boot small clamp is installed, the inboard hub must be set to a service build length.
(a) Compress the inner hub down the connector shaft.
(b) Use a small blunt drift between the large end and the boot seal to relieve the pressure.
(c) The distance edge of the lip to the edge of the flange should be 181.00 mm (7.13 inch). This will eliminate excess air that can cause a
ballooning affect and possibly cause damage to the boot.
12. Verify that the boot is not twisted and that it is correctly positioned on the housing.
13. Install the large ladder clamp on the boot and secure as done with the small ladder clamp.
