Durango 4WD V8-5.9L VIN Z (1998)
Power Window Switch: Testing and Inspection
The Light-Emitting Diode (LED) illumination lamps for all of the power window and lock switch and bezel unit switch paddles receive battery current
through the power window circuit breaker in the junction block. If all of the LEDs are inoperative in both the power window and lock switch units and
the power windows are inoperative, perform the diagnosis for Power Window System. If the power windows operate, but any or all of the LEDs are
inoperative, the power window and lock switch units with the inoperative LED(s) is faulty and must be replaced.
1. Check the circuit breaker in the junction block. If OK, go to Step 2. If not OK, replace the faulty circuit breaker.
2. Turn the ignition switch to the On position. Check for battery voltage at the circuit breaker in the junction block. If OK, turn the ignition switch to
the Off position and go to Step 3. If not OK, repair the circuit to the ignition switch as required.
3. Disconnect and isolate the battery negative cable. Remove the power window switch unit from the door trim panel. Unplug the wire harness
connector from the switch unit.
Power Window Switch Continuity - Driver Side Front
