Durango 4WD V8-5.9L VIN Z (1998)
Windshield Washer Pump: Service and Repair
REMOVAL
Front
1. Remove the washer reservoir from the engine compartment. See Washer Reservoir in the Replacement for the procedures.
2. Using a trim stick or another suitable wide flat-bladed tool, gently pry the barbed inlet nipple of the washer pump out of the rubber grommet seal
in the reservoir. Care must be taken not to damage the reservoir.
3. Remove the rubber grommet seal from the reservoir and discard.
4. Reverse the removal procedures to install. Always use a new rubber grommet seal on the reservoir.
Rear
1. Remove the washer reservoir from the passenger compartment. See Washer Reservoir in the Replacement for the procedures.
2. Using a trim stick or another suitable wide flat-bladed tool, gently pry the barbed inlet nipple of the washer pump out of the rubber grommet seal
in the reservoir. Care must be taken not to damage the reservoir.
3. Remove the rubber grommet seal from the reservoir and discard.
4. Reverse the removal procedures to install. Always use a new rubber grommet seal on the reservoir.
