Durango 4WD V8-5.9L VIN Z LDC (1999)
6. Measure back (counterclockwise) 10 mm (0.40 inch) and mark housing.
7. Rotate adjustment cap back (counterclockwise) with spanner wrench until hole is aligned with the second mark.
8. Install and tighten locknut to 108 Nm (80 ft. lbs.). Be sure adjustment cap does not turn while tightening the locknut.
OVER-CENTER
NOTE: Before performing this procedure, the worm bearing preload adjustment must be performed.
1. Rotate the stub shaft with a 12 point socket from stop to stop and count the number of turns.