Grand Caravan V6-3.3L Flex Fuel (2008)
The passenger side wiring harness has one additional wiring harness retainer at the side impact sensor (Figure 6 caption).
14. Disconnect the 10 way power sliding door harness connector from the body wiring harness connector located at the lower "B" post. Push the red
locking tab in the direction of the power sliding door harness, then push down on the release tab while separating the connectors.
15. Remove the power sliding door harness from the door track by carefully pulling the harness retainers out of the retention holes (Figure 6).
16. Place the new power sliding door harness into position in the door track.
17. Insert the double wiring harness retainers into the door track retention holes and then insert the two lower "B" post wiring harness retainers into the
retention holes (Figure 6).
18. Connect the 10 way power sliding door wiring harness connector to the body wiring harness connector located at the lower "B" pillar and slide the
red locking tab in the direction of the body wiring harness.
19. Connect the side impact sensor connector (Figure 6).
NOTE:
The passenger side wiring harness at the side impact sensor has one additional wiring harness retainer (Figure 6 caption).
20. Move the chain link track and wiring harness rearward.
21. Install the supplied tab/wedge on the lower hinge pivot located on the sliding door lower hinge (Figure 5).
NOTE:
The tab/wedge must have the "L" facing up on the drivers side of the vehicle and the "R" facing up on the passenger side of the vehicle (Figure
7).
22. While holding the tab/wedge in place, snap the chain link to the lower hinge pivot.
23. Lock the chain link in place by pushing the locking tab rearward (Figure 5).
24. Insert the power sliding door wiring harness retainers into the lower hinge and sliding door retention holes (Figure 4).
25. Connect the 10 way power sliding door wiring harness connector to the sliding door wiring harness connector and slide the gray locking tab
downward (upward on the passenger side of the vehicle) (Figure 4).
26. Connect the power sliding door switch, located on the lower "B"post trim panel, to the body wiring harness connector.