Grand Caravan V6-3.3L Flex Fuel (2008)
7. Remove the third row upper turning loop anchor bolt.
8. Remove the six quarter trim retaining screws.
9. Pull trim from inner quarter panel (1).
10. Left quarter trim only - Disconnect the auxiliary power outlet and power inverter (2) wire harness connectors (3) (if equipped).
11. Remove the quarter trim panel (5).
Quarter Trim Panel - Installation
INSTALLATION
1. Position the left quarter trim panel (5) into the vehicle.
2. Left quarter trim only - Connect the auxiliary power outlet and power inverter (2) wire harness connectors (3) (if equipped).
3. Align the trim panel over the retaining slots on the inner quarter panel (1) and firmly snap into place.
4. Install the six quarter trim retaining screws.
5. Right quarter trim only - install the second row seat belt webbing anchor bolt.
6. Install the third row upper turning loop anchor bolt.
7. Install the third row lower seat belt webbing anchor (4).
8. Install the quarter trim bolsterSee: Quarter Panel Trim/Quarter Trim Bolster/Installation.
9. Install the upper D-pillar trimSee: Pillar Trim/D-Pillar Trim/Installation.
10. Install the liftgate scuff plateSee: Scuff Plate/Service and Repair/Liftgate Sill Scuff Plate - Installation.
11. Close liftgate.
Removal
REMOVAL
1. Remove the table from the base.
2. Hoist vehicle.
3. From underneath vehicle, remove the six nuts (3) to the table base.
4. Lower the table base backing plate (2) from the vehicle.