Grand Caravan V6-3.3L Flex Fuel (2008)
Power Trunk / Liftgate Control Module: Service and Repair
Installation
INSTALLATION
1. Position the power liftgate control module (2) into the vehicle.
2. Insert the mounting tab into the locating slot on the inner quarter panel (1).
3. Install the power liftgate control module push pin style retainer (3).
4. Connect the wire harness connectors (4) to the power liftgate control module.
5. If equipped, install the subwoofer,See: Accessories and Optional Equipment/Radio, Stereo, and Compact Disc/Speaker/Service and
Repair/Speaker - Removal.
6. Install the left quarter trim panel (5).
a. Position the left quarter trim panel (5) into the vehicle.
b. Connect the auxiliary power outlet and power inverter (2) wire harness connectors (3) (if equipped).
c. Align the trim panel over the retaining slots on the inner quarter panel (1) and firmly snap into place.
d. Install the six quarter trim retaining screws.
e. Install the third row upper turning loop anchor bolt.
f.
Install the third row lower seat belt webbing anchor (4).
7. Install the quarter trim bolster (5).
a. Position the quarter trim bolster (5) into the vehicle and slide the rear seat belt (3) into the slot.
b. Align the locating tabs (4) with the holes in the left quarter trim panel.
c. Carefully engage the quarter trim bolster upper retaining tabs (2) by inserting them into the left quarter trim panel and swinging the bottom
edge of the bolster towards the left quarter trim.
