Grand Caravan V6-3.3L Flex Fuel (2008)
Cruise Control Switch: Service and Repair
Removal
REMOVAL
WARNING: Disconnect and isolate the battery negative (ground) cable before beginning steering wheel removal or installation. Allow the front
airbag system capacitor to discharge for two minutes before removing the steering wheel or any front airbag system component. This will
disable the front airbag system. Failure to disconnect the battery could result in accidental front airbag module deployment and possible
personal injury.
Do not place a non-deployed airbag face down on a hard surface as the airbag will propel into the air if accidentally deployed, and could result
in serious or fatal injury.
1. Disconnect and isolate the negative battery cable before beginning steering wheel removal. Allow the front airbag system capacitor to discharge
for two minutes before removing the steering wheel or any front airbag system component.
2. Remove steering wheel air bag,See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Driver Airbag -
Removal.
3. Disconnect electrical connector (1) from speed control switch (3).
4. Remove screws (2) from speed control switch (3).
5. Remove speed control switch (3) from steering wheel.
