Grand Caravan V6-3.3L Flex Fuel (2008)
5. Install each main cap and tighten bolts finger tight.
6. Tighten number 1, 3 and 4 main cap bolts to 41 Nm + 1/4 Turn (30 ft. lbs.+ 1/4 Turn).
7. Rotate the crankshaft until the number 6 piston is at TDC.
8. To ensure correct thrust bearing alignment the following procedure must be done:
-
Move crankshaft all the way to the rear of its travel.
-
Then, move crankshaft all the way to the front of its travel.
-
Wedge an appropriate tool between the rear of the cylinder block and rear crankshaft counterweight. This will hold the crankshaft in it's most
forward position.
-
Tighten the #2 Thrust Bearing cap bolts to 41 Nm + 1/4 Turn (30 ft. lbs.+ 1/4 Turn). Remove the holding tool.
9. Install oil pan.See: Engine Lubrication/Oil Pan/Service and Repair/Removal and Replacement/Engine Oil Pan - Installation
10. Fill engine crankcase with proper oil to correct level.