dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Blend Door Actuator - Removal|Page 8069 > < Blend Door Actuator - Removal|Page 8067
Page 5
background image

NOTE: LHD model shown. RHD model similar.

1. Position the mode door actuator (1) to the bracket (2) on driver side of the HVAC air distribution housing and connect the wire harness connector

(4) to the actuator and engage the red locking tab.

2. Install the mode door actuator onto the bracket. If necessary, rotate the actuator slightly to align the splines on the actuator with the mode door

linkage.

3. Install the two screws (2) that secure the mode door actuator to the bracket. Tighten the screws to 1.2 Nm (10 in. lbs.).
4. Install the lower trim panel (3) onto the passenger side of the instrument panel.
5. Install the lower glove box bin.
6. If equipped, install the silencer underneath the passenger side of the instrument panel.
7. Reconnect the negative battery cable.
8. Calibrate the A/C-heater controlSee: Service and Repair/Procedures/HVAC Actuator Calibration Procedure.

Rear Controls

INSTALLATION

1. Position the rear mode door actuator (3) onto the rear heater-A/C housing (1). If necessary, rotate the actuator slightly to align the splines on the

actuator output shaft with those on the rear mode-air door coupler.

2. Install the two screws (4) that secure the rear mode door actuator to the rear heater-A/C housing. Tighten the screws to 1.2 Nm (10 in. lbs.).
3. Connect the wire harness connector (2) to the rear mode door actuator.
4. Install the rear heater-A/C housing.
5. Calibrate the A/C-heater controlSee: Service and Repair/Procedures/HVAC Actuator Calibration Procedure.

Recirculation Door Actuator - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may
result in accidental airbag deployment and possible serious or fatal injury.

Blend Door Actuator - Removal|Page 8069 > < Blend Door Actuator - Removal|Page 8067