Grand Caravan V6-3.3L Flex Fuel (2008)
7. Install return hose (5) into power steering gear (3) port. Thread return hose tube nut into gear and tighten to 31 Nm (23 ft. lbs.).
8. Install pressure hose (4) into power steering gear (3) port. Thread pressure hose tube nut into gear and tighten to 31 Nm (23 ft. lbs.).
NOTE: Before stabilizer bar installation, inspect the cushions and links for excessive wear, cracks, damage and distortion. Replace any
pieces failing inspection.
NOTE: Before installing the stabilizer bar, make sure the bar is not upsidedown. The stabilizer bar must be installed so that when in mounted
position, the ends of the bar curve under the steering gear tie rods, up to the links.
9. Install the stabilizer bar through the driver side wheel opening. Rotate the bar as necessary until it is centered over the suspension crossmember
and the ends curve upward below the steering gear tie rods.
10. Install the two cushions (bushings) on the stabilizer bar utilizing the slit cut into the cushion sides.
11. Install the two stabilizer bushing retainers (2) over the cushions.
12. Install the four screws (1) securing the stabilizer bushing retainers (2) to the crossmember. Tighten screws to 45 Nm (33 ft. lbs.).
13. Position the power steering pressure hose routing clamp(s) (4.0L engine only uses one) on the rear of the crossmember. Install and tighten the
screw(s) to 8 Nm (71 in. lbs.).
14. Install the rear engine mount.See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Engine Mount/Service and
Repair/Engine Mount - Installation
