Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
Figure 2 REMOVING SLIDING DOOR LATCH/LOCK ASSEMBLY
Installation
INSTALLATION
1. Position latch/lock locking lever in unlocked position.
2. If equipped, engage wire connector into power door lock motor (Figure 2).
3. Place latch/lock in position on door (Figure 1).
CAUTION: REPLACE BOLTS IF INSTALLING NEW LATCH.
4. Insert bolt into slots in sliding door inner panel.
5. Tighten bolts attaching latch/lock assembly to sliding door.
6. Engage inside cable into latch/lock assembly.
7. Install inside door handle assembly.
8. Install foam block.
9. Engage external cable to latch/lock assembly.
10. Engage link rod to bellcrank.
11. Engage hold open latch cable from lower hinge.
12. Engage clip to hold bellcrank link to latch/lock control.
13. Verify sliding door operation.