Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
Door Lock Cylinder: Service and Repair
Installation
INSTALLATION
1. Engage clip into outside handle to hold lock cylinder (Figure 1).
2. With link arm toward rear of vehicle, push lock cylinder into door handle until clip snaps into place .
3. Insert lock linkage into door latch.
4. Engage clip to hold door lock linkage to latch.
5. Insert latch linkage into door latch.
6. Engage clip to hold door latch linkage to latch.
7. Install push in fasteners attaching VTSS switch harness to inner door reinforcement bar, if equipped.
8. Connect VTSS switch connector into door harness, if equipped.
9. Verify door latch operation.
10. Install watershield and door trim panel.
Figure 1 OUTSIDE DOOR HANDLE
