Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
Assembly - Master Cylinder (Fluid Reservoir)
ASSEMBLY - MASTER CYLINDER (FLUID RESERVOIR)
1. Install new master cylinder housing to brake fluid reservoir sealing grommets in master cylinder housing (Figure 2).
2. Lubricate reservoir mounting area with fresh clean brake fluid. Place reservoir in position over sealing grommets. Seat reservoir into sealing
grommets using a rocking motion while firmly pressing down on fluid reservoir.
3. Be sure fluid reservoir is positioned properly on master cylinder. Bottom of fluid reservoir is to be touching the top of both sealing grommets
when properly installed on master cylinder housing.
4. Install the two fluid reservoir to master cylinder retaining pins (Figure 1).
5. Install the master cylinder assembly on the power brake booster.
6. Fill fluid reservoir to its proper level as indicated on the side of the fluid reservoir.
Figure 1 Fluid Reservoir Retaining Pins (Typical)
Figure 2 Master Cylinder To Fluid Reservoir Seal Grommets
