Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
15. Pull the front parking brake cable assembly out of the vehicle through the hole in the floor pan.
Figure 5 Front Park Brake Cable At Floor Pan
Installation - Fold-In-Floor Seating
INSTALLATION - FOLD-IN-FLOOR SEATING
1. Pass most of the front parking brake cable assembly down through hole in the floor pan from inside the vehicle.
2. Pass the lever-end cable strand button through the hole in the lever (pedal) assembly bracket.
3. Install the end of the cable housing into the retainer installed into the park brake pedal bracket.
4. Install cable strand button into the reel on the parking brake lever mechanism (Figure 4).
5. Install the front parking brake cable floor pan seal into the hole in the floor pan. The seal flange should be flush with the floor pan (Figure 2).
6. Reposition the carpeting back down on the floor.
7. Install the left front kick panel.
8. Install the left front door sill molding.
9. Raise and support the vehicle.
10. Pass the end of the cable through the hole in the end of the intermediate bracket (Figure 3). Press the cable housing retainer through the hole until
the fingers on the retainer lock it into place.
11. Attach the front cable to the routing clips fastened to the underbody of the vehicle (Figure 3).
12. Clamp an appropriate pair of locking pliers on the front cable strand approximately 25 mm (1 inch) forward of the button (Figure 1).