Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
Figure 1 UPPER MANIFOLD TIGHTENING SEQUENCE
5. Connect the MAP sensor electrical connector.
6. Connect the brake booster and LDP vacuum hose to intake manifold (Figure 4).
CAUTION: The special screws used for attaching the EGR tube and power steering reservoir to the manifold must be installed slowly
using hand tools only. This requirement is to prevent the melting of material that causes stripped threads. If threads become stripped, an
oversize repair screw is available..
7. Install the power steering reservoir (Figure 3). Tighten screws to manifold to 5.6 Nm (50 in. lbs.).
8. Connect throttle and speed control cables to throttle body
9. Attach make up air hose clip into the hole in the throttle cable bracket.
10. Connect the wiring connectors to the throttle position sensor (TPS) and Automatic Idle Speed (AIS) motor.
Figure 2 PCV HOSE
NOTE: PCV valve MUST be seated into the right cylinder head cover. The PCV valve hose MUST cover the right cylinder head cover,
PCV housing completely. Failure to do so may cause higher idle and emission faults.
11. Install PCV hose (Figure 2).
12. Install air cleaner and air inlet hose assembly.
13. Connect the inlet air temperature (IAT) sensor electrical connector.
14. Connect battery negative cable.