Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
7. Install crankshaft front oil seal.
8. Install water pump and pulley.
9. Install crankshaft vibration damper.
10. Install engine mount bracket (Figure 4) and tighten M10 to 54 Nm (40 ft. lbs.), M8 bolt to 28 Nm (21 ft. lb. lbs.).
11. Install idler pulley on engine mount bracket (Figure 4).
12. Install right side engine mount.
13. Install camshaft position sensor.
14. Connect the heater return hose at rear of timing chain cover (Figure 3) or at water pump inlet tube (if engine oil cooler equipped) (Figure 5).
15. Connect the radiator lower hose.
16. Install A/C compressor.
17. Install accessory drive belt.
18. Install oil pump pick-up tube with new O-ring. Tighten attaching bolt to 28 Nm (250 in. lbs.).
19. Install oil pan.
20. Install inner splash shield and right front wheel.
21. Fill crankcase with engine oil to proper level.
22. Fill cooling system.
23. Connect negative cable to battery.
Figure 3 HEATER RETURN HOSE (Without Engine Oil Cooler)
