Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
4. Disconnect the drain tube from the wiper module drain on the right side of the engine compartment.
5. Remove the A/C pressure transducer.
6. If equipped, remove the nut that secures the A/C ground strap eyelet to the weld stud on the top of the right front strut tower and remove the strap
from the stud (Figure 1).
7. Remove the bolt that secures the rear section of the front liquid line to the top of the receiver/drier.
8. Disconnect the rear section of the front liquid line from the top of the receiver/drier and remove and discard the O-ring seal.
9. Install plugs in, or tape over the opened liquid line fitting and the receiver/drier port.
10. Remove the nut that secures the A/C suction and liquid lines to the A/C expansion valve.
11. Disconnect the A/C suction and liquid lines from the A/C expansion valve and remove and discard the O-ring seals.
12. Install plugs in, or tape over the opened suction and liquid line fittings and expansion valve ports.
Figure 1 LIQUID LINE (FRONT SECTION)
