Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
Impact Sensor: Service and Repair
Removal
REMOVAL
FRONT IMPACT SENSOR
The right and left front impact sensors are mounted identically on the front rail tips.
1. Open hood, disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component
service. Failure to do so may result in accidental airbag deployment, personal injury or death.
2. Hoist vehicle.
3. Disconnect electrical connector (Figure 1).
4. Remove the two screws attaching front impact sensor to outer rails (Figure 1).
Figure 1 FRONT IMPACT SENSOR REMOVE/INSTALL
5. Remove sensor from vehicle.
SIDE IMPACT SENSORS
B-PILLAR MOUNTED
The right and left front row side impact sensors, are mounted identically, on opposite sides of the vehicle, in the b-pillar.
1. Open hood, disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the system reserve capacitor to discharge before beginning any airbag component service. Personal
injury or death may result.
2. Remove the B-pillar lower trim for the side of the vehicle that you are replacing the side impact sensor.
3. Disconnect the electrical connector from the impact sensor (Figure 2).