Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
Figure 2 Bearing Shim and Race
Figure 3 Installing Bearing Race
CAUTION: The original shim must be installed behind the bearing cup to maintain proper bearing preload.
4. Apply Mopar(R) Gasket Maker, Loctite Gasket Eliminator No. 518 or equivalent to sealing surfaces of end cover.
5. Place end cover onto P.T.U. case and install bolts. Tighten bolts to 28 Nm (250 in. lbs.) in the sequence shown in (Figure 4). Retighten first bolt
after all others are tight.
CAUTION: When end cover is installed be careful not to damage the P.T.U. Input Shaft Cover Seal.