Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
3. Install input shaft.
4. Install oil trough.
5. Apply Mopar(R) Gasket Maker or equivalent to sealing surfaces of end cover and reinstall. Tighten bolts to 28 Nm (250 in. lbs.)
CAUTION: When end cover is installed be careful not to damage the P.T.U. Input Shaft Cover Seal.
6. Reinstall P.T.U. assembly into vehicle.
7. Check and fill fluids as required.
Removal
REMOVAL
The outer half shaft seal is located on the outside of the end cover. The P.T.U. does not have to be removed to replace this seal.
1. Lift vehicle on hoist.
2. Remove right front half shaft from vehicle.
3. Remove seal with a chisel and hammer (Figure 1).
Figure 1 Seal Removal