Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
Windshield Washer Reservoir: Service and Repair
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the engine fresh air housing inside the engine compartment.
3. Disconnect the washer hose at the in-line connector forward of the cowl grille so that the in-line connector remains with the washer hose from the
fresh air plenum.
4. Disconnect the washer hose from the hose clip located on the front fender side shield.
5. Remove the filler tube screw.
6. Hoist and support vehicle on hoist or jack stands.
7. Remove the right front wheel and tire assembly.
8. Disconnect the left right front wheelhouse splash shield and move aside.
9. Drain washer fluid from the reservoir and into a suitable clean container. This can be done by disconnecting the windshield washer hose from the
front (outboard) washer pump port allowing the washer fluid to drain into a container through a temporary jumper hose connected to the washer
pump port.
10. Disconnect the electrical body harness connectors to the washer pump motor and the fluid level sensor. Slide the red lock on the connector to the
release position, then, depress the black tab and pull the connector off the pump or sensor.
11. Remove the two reservoir mounting screws.
12. Disconnect the reservoir from the body mount by raising the reservoir upward slightly and then down so that the reservoir filler neck and front
washer hose pull through the opening in the front fender side shield.
