Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
Figure 2 WIPER MODULE
11. Lift wiper module from weld-studs on lower windshield fence.
CAUTION: Do not allow wiper module to rest on brake master cylinder reservoir, damage to brake system can result.
12. Remove wiper module and set on bench.
NOTE: If replacing the wiper tub, the components must be transferred to the new tub.
Installation
INSTALLATION
NOTE: If replacing the wiper tub, the components must be transferred to the new tub.
1. Position the wiper module into the cowl.
2. Install the bolts that secure the wiper module to the dash (Figure 2). Tighten bolts to 17 Nm (150 in.lbs.).
3. Install the nuts that retain the wiper module to the bulkhead fenceline. Tighten nuts to 7 Nm (62 in.lbs.).
4. Connect the drain tubes to the nipples on the wiper module.
5. Connect the windshield washer tube.
6. Connect the wire harness connector to the wiper module (Figure 2).
7. Connect the positive lock on the wiper module wire connector (Figure 1).
CAUTION: Do not allow wiper module to rest on brake master cylinder reservoir, damage to brake system can result.
8. Install the cowl cover.
9. Install the wiper arms and blades. Tighten nuts to 37 Nm (27 ft.lbs.).
10. Connect the battery negative cable.
11. Close the hood.
