Grand Caravan V6-3.3L VIN R (2005)
Power Trunk / Liftgate Hazard Sensor: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove trim panel from liftgate.
Pinch Sensor Location
3. Disconnect the pinch sensor wire harness connector.
4. Remove screws holding the pinch sensor to lift-gate.
5. Feed the pinch sensor wire harness out of the liftgate and remove the sensor from the vehicle.
INSTALLATION
WARNING: USE EXTREME CAUTION WHEN TESTING PINCH SENSOR OPERATION.
CAUTION: Ensure liftgate surface is clean and dry prior to pinch sensor installation. Failure to do so will inhibit the adhesive backings ability to
adhere to the liftgate and cause improper system operation or premature component failure.
1. Position the pinch sensor to the liftgate.
2. Install the third screw from the top of the sensor first. Do not torque screw at this time.
3. Install the remaining three screws holding the sensor to the liftgate. Torque all screws to 25 in. lbs.
