Grand Caravan V6-3.3L VIN R (2005)
Electronic Brake Control Module: Service and Repair
Antilock Brake Module (MK25E)
REMOVAL
1. Disconnect the negative (ground) cable from the battery and isolate it.
2. Remove the battery shield and battery.
3. Disconnect the vacuum hose connector at the tank built into the battery tray.
4. Remove the screw securing the engine coolant filler neck to the battery tray.
5. Remove the battery tray.
CAUTION: Before disassembling the ICU, the ICU must be thoroughly cleaned. This must be done to prevent dirt particles and debris from
entering into vital areas of the ICU.
6. Thoroughly clean all surfaces of the ICU and brake tubes. Use only a solvent such as Mopar Brake Parts Cleaner or equivalent.
ABM Connector Release Tabs
Wiring Harness Connector At ABM
7. Disconnect the 47-way connector from the antilock brake module (ABM) by depressing the tabs on each side of the connector cover (Fig. 2), then
pulling outward and upward on the lower half of the cover until it locks into position pointing straight outward. The connector can then be pulled
straight outward off the ABM.