Grand Caravan V6-3.3L VIN R (2005)
CAUTION: When installing guide pin bolts extreme caution should be taken not to cross-thread the caliper guide pin bolts.
4. Install the caliper guide pin bolts. Tighten the guide pin bolts to a torque of 35 Nm (26 ft. lbs.).
CAUTION: When connecting the brake hose to the caliper, install new brake hose to caliper special washers.
5. Install the brake hose on the caliper. To do this, first place one NEW special copper washer on each side of the hose fitting, then slide the banjo
bolt through the fitting. Next, thread the banjo bolt into the threaded port on the rear of the brake caliper. Tighten the banjo bolt to a torque of 47
Nm (35 ft. lbs.).
6. Install the wheel and tire assembly.
7. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the
full specified torque of 135 Nm (100 ft. lbs.).
8. Lower the vehicle.
9. Remove the brake pedal depressor (holding) tool.
10. Bleed the hydraulic brake circuit to the brake caliper.
11. Road test the vehicle and make several stops to wear off any foreign material on the brakes and to seat the brake shoe linings.
