Grand Caravan V6-3.3L VIN R (2005)
12. Pull the parking brake cable strand forward and disconnect the end button from the lever (pedal) assembly mechanism reel (Fig. 106).
13. Slide the cable out of the lever bracket.
14. Lift back the carpet and pull the cable seal loose from the floor pan (Fig. 102).
15. Pull the front parking brake cable assembly out of the vehicle through the hole in the floor pan.
REMOVAL - EXPORT
Refer to BASE/PARKING BRAKE/LEVER - REMOVAL
INSTALLATION
1. Pass front parking brake cable assembly through hole in floor pan from the inside of the vehicle.
2. Pass cable strand button through the hole in the lever (pedal) assembly bracket.
3. Install cable retainer onto the park brake cable and then install cable retainer into pedal assembly bracket.
4. Install the end of the park brake cable into the retainer previously installed into the park brake pedal bracket.
5. Install cable strand button into the clevis on the park brake pedal mechanism.
6. Install the front park brake cable floor pan seal into hole in floor pan. Seal is to be installed so the flange on the seal is flush with the floor pan
(Fig. 102). Fold carpeting back down on floor.
7. Raise vehicle.
8. Insert brake cable and housing into body outrigger bracket making certain that housing retainer fingers lock the housing firmly into place (Fig.
101).
9. Manually reset the automatic self-adjusting mechanism tension of the parking brake lever (pedal) assembly.
10. Assemble the park brake cables onto the park brake cable equalizer (Fig. 100).
11. Lower vehicle and apply the park brake pedal 1 time. This will seat the parking brake cables.
INSTALLATION - FOLD-IN-FLOOR SEATING
1. Pass most of the front parking brake cable assembly down through hole in the floor pan from inside the vehicle.
2. Pass the lever-end cable strand button through the hole in the lever (pedal) assembly bracket.
3. Install the end of the cable housing into the retainer installed into the park brake pedal bracket.
4. Install cable strand button into the reel on the parking brake lever mechanism (Fig. 106).
5. Install the front parking brake cable floor pan seal into the hole in the floor pan. The seal flange should be flush with the floor pan (Fig. 102).
6. Reposition the carpeting back down on the floor.
7. Install the left front kick panel.
8. Install the left front door sill molding.
9. Raise and support the vehicle.
10. Pass the end of the cable through the hole in the end of the intermediate bracket (Fig. 104). Press the cable housing retainer through the hole until
the fingers on the retainer lock it into place.
11. Attach the front cable to the routing clips fastened to the underbody of the vehicle (Fig. 104).
