dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Parking Brake Shoe > < Parking Brake Lever|Service and Repair
Page 2
background image

15. Remove the parking brake lever assembly from the cable.

INSTALLATION

1. Install the parking brake cable end housing into the mounting hole in the parking brake lever (pedal) assembly.
2. Install cable strand button into the reel on the parking brake pedal mechanism (Fig. 125).
3. Connect the wiring connector to the indicator lamp ground switch (Fig. 125).
4. Install the release link on the release mechanism of the parking brake lever.
5. Position the lever into its installed position on the body of the vehicle.
6. Loosely install the top bolt mounting the lever to the body (Fig. 124).
7. Loosely install the forward nut mounting the lever to the body (Fig. 124).
8. Loosely install the lower bolt mounting the lever to the body (Fig. 124).
9. Tighten lever mounting bolts and nut to 28 Nm (250 inch lbs.).

10. Verify that the parking brake lever is in the fully released (full up) position.
11. Raise and support the vehicle.
12. Install the front parking brake cable on the cable equalizer. If a new lever assembly is NOT being installed, perform PARKING BRAKE

AUTOMATIC ADJUSTER TENSION RESET as necessary.

NOTE:  If the original lever assembly is being used, the lever mechanism auto adjuster spring tension will need to be reset.

13. Lower vehicle.
14. If a new lever is being installed, remove the lockout pin from the automatic adjuster on the parking brake lever mechanism allowing the automatic

self-adjusting mechanism in the lever to take up any slack (Fig. 125).

15. Install the electrical junction block on the instrument panel.
16. Install the reinforcement on the lower instrument panel.
17. Install the steering column lower cover on the lower instrument panel.
18. Install the left side kick panel.
19. Install the sill scuff plate on the lower sill of the left door.
20. Install the negative (ground) cable on the battery.
21. Cycle the parking brake pedal one time. This will seat the park brake cables and allow the automatic self-adjuster to properly tension the parking

brake cables.

Parking Brake Shoe > < Parking Brake Lever|Service and Repair