Grand Caravan V6-3.3L VIN R (2005)
19. Remove the hub/bearing (Fig. 140).
CAUTION: Corrosion may occur between the hub/bearing and the axle flange. If this occurs, the hub/bearing will be difficult to remove from the
axle and disc brake caliper adapter. If the hub/bearing will not come out by pulling on it by hand, don't not pound on it with a hammer. Pounding
on the hub/bearing will damage it. To remove a hub/bearing that is corroded in place, lightly tap the disc brake caliper adapter using a soft-face
hammer. This will remove both the caliper adapter and hub/bearing together from the axle. With a helper supporting the caliper adapter in his
hands, position Remover, Special Tool 8214-1, on the cast housing of hub/bearing (Fig. 141). Do not position the special tool on the inner race of
hub/bearing. Lightly strike the Remover with a hammer to remove the hub/bearing from the caliper adapter.
20. Remove the adapter from the rear axle.