Grand Caravan V6-3.3L VIN R (2005)
side service port. The rear connects between the receiver/drier and the A/C expansion valve and includes the fitting for the A/C pressure transducer. On
models equipped with the rear heating-A/C system, the rear of the front A/C liquid line also includes a hose and tube extension that connects the front
liquid line to the liquid line for the rear A/C system.
REMOVAL
1. Recover the refrigerant from the refrigerant system.
2. Disconnect and isolate the negative battery cable.
3. Remove the air cleaner housing and the air inlet tube.
4. Disconnect the drain tube from the wiper module drain on the right side of the engine compartment.
5. Remove the A/C pressure transducer.
A/C Liquid Line - LHD Shown, RHD Typical
6. If equipped, remove the nut that secures the A/C ground strap to the weld stud on the top of the right front strut tower.
7. If equipped, remove the A/C ground strap eyelet terminal connector from the weld stud.
8. Remove the bolt that secures the rear of the A/C liquid line to the receiver/drier.
9. Disconnect the A/C liquid line from the receiver/drier and remove and discard the O-ring seal.
10. Install plugs in, or tape over the opened liquid line fitting and the receiver/drier outlet port.
11. Remove the nut that secures the A/C suction line and the A/C liquid line to the A/C expansion valve.
12. Disconnect the A/C suction line and the A/C liquid line from the A/C expansion valve and remove and discard the O-ring seals.
13. Install plugs in, or tape over the opened suction line and liquid line fittings and both expansion valve ports.
14. On RHD models, remove the rear of the A/C liquid line from the retaining bracket located at the top of the dash panel
15. If the vehicle is equipped with the optional rear heating-A/C system, go to Step 16. If the vehicle is not equipped with the optional rear
heating-A/C system, go to Step 22.
16. Raise and support the vehicle.