Grand Caravan V6-3.3L VIN R (2005)
Do not allow the grinding wheel to touch the aluminum heater tubes.
15.
Remove the aluminum crimp band from the hose using expanding snap-ring pliers (Snap-on SRP5A or equivalent) (Figure 2).
16.
Slide the spring clamps off the heater hoses (Figure 3).
17.
Remove the heater hoses from the vehicle.
18.
Remove and save the spring clamps on the old hoses. Then discard the old hoses 19. Install two spring clamps onto each heater tube.
20.
Using the long hoses supplied in the kit, install the new heater hoses onto the heater hose tubes.
21.
Place the spring clamps at each end of the new heater hose.
NOTE:
The wings of the spring clamp should be pointed downward.
22.
Install the tire heat shields.
23.
Lower the vehicle.
24.
Remove the pinch-off pliers on the heater hoses in the engine compartment.
25.
Raise the spare tire into position using the crank handle inside the vehicle.
26.
Check the engine coolant level and add coolant as required.
27.
Start the engine and ensure that the new heater hoses do not leak.
