Grand Caravan V6-3.3L VIN R (2005)
The following list indicates the priority of the chime when more than one chime is active at the same time:
-
Seat belt warning
-
High-speed warning Gulf Coast Countries (GCC) only
-
Turn signal on
-
Chime request
-
Warning lamp announcement
The cluster is responsible to set priority on all warning lamp announcement chimes.
CHIME ON CONDITIONS
The following is a list of the chime warnings and when they will sound.
Driver's Seatbelt Unbuckled: Sounds for approximately 6 ± 2 seconds when the ignition is turned on driver's seat belt is not buckled, as a reminder to
the driver to buckle the seat belt.
Exterior Lights On:Ignition is in the lock position, the driver door is ajar, and the headlight switch is left in any position, other than auto or off.The
chime will sound as a warning to the driver until one of the above conditions is removed or until the battery protection time of 3 minutes has expired.
Key-In Ignition: Ignition is in the lock position, driver door is ajar and the key is in the ignition. The chime will sound until one of the above conditions
is removed or until the battery protection time of 15 minutes has expired.
Turn Signal On: When the BCM detects a turn signal input continuously for 1.0 mile/0.6 km and the vehicle speed is greater than 15 mph/24 kph, the
chime will sound until the specific turn signal is cancelled.
Dome Lights On: Ignition is in the lock position, driver door ajar, and the dome light switch is left in the on position. The chime will sound until one of
the above conditions is removed or until the battery protection time of 15 minutes has expired.
Low Oil Pressure: The chime will sound when the engine is operating and the oil pressure drops below 4 psi/27.5 kPa.
Engine Temperature Critical: The chime will sound when the engine is operating and the coolant temperature exceeds 252° F/122° C or 234° C/112°
C(diesel). The chime is continuous at 257° F/ 125° C and will chime for 4 minutes and stop if the temperature drops below 255° F/123° C. Low
Washer The chime will sound when the Fluid washer fluid drops below a specific level.
Warning Lamp Announcement: A chime will sound to alert the driver to scan the instrument panel and overhead console to see which warning lamp is
illuminated. The door/liftgate ajar warning lamp will appear without a chime if the vehicle is running and a door or the liftgate is opened. A chime will
sound if the door or liftgate is still open and the vehicle speed is greater than 4 mph/6 kph.
High-speed warning Gulf Coast Countries (GCC) only The chime will sound, acting as a warning to the driver that the vehicle speed has exceed 75 mph
± 2/120 kph ± 3.
WARNING LAMP ANNOUNCEMENT
Low Fuel Lamp: The cluster will request a single chime after the indicator is illuminated.
Volt Lamp: The cluster will request a single chime after the indicator is illuminated.
Oil Pressure Lamp: The cluster will request a single chime after illuminating the indicator above 450 rpm vehicle operation.
Liftgate Ajar Lamp: The BCM determines when to chime for liftgate ajar.
Fasten Seat Belt Lamp: The MIC will request a single chime from the BCM when the ignition is turned to the unlock/ run/start positions if the driver
seat belt is not buckled and 2 seconds after seatbelt warning chime ends.
Check Engine Lamp: The cluster will request a single chime after the indicator is illuminated.
Low Washer Fluid Lamp: The cluster will request a single chime after the indicator is illuminated.
Engine Temperature Lamp: The cluster will request a single chime when the indicator is first illuminated at 252° F/122° C.
OTHER CHIME ON CONDITIONS
Programming of an Additional Key Fob: A single cluster chime will sound, which signals that the program mode has been initiated.
Programming for Rolling Door Locks: When the programming has been completed, a single tone from the chime system, will occur.
Communication
