Grand Caravan V6-3.3L VIN R (2005)
Front Row Side Impact Sensor/Bracket
5. Remove impact sensor from vehicle.
INSTALLATION
1. Position sensor bracket in vehicle.
2. Install the four retaining screws to the impact sensor bracket. Torque screws to 7 Nm (62 in. lbs.).
3. Connect the electrical connector.
4. Install the B-pillar lower trim for the side of the vehicle that you are replacing the side impact sensor.
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE
SYSTEM TEST IS NOT PERFORMED FIRST.
5. Verify vehicle and system operation.
6. Close hood.
Sliding Door Opening Mounted
REMOVAL
The right and left second row side impact sensors, are mounted identically, on opposite sides of the vehicle, in the sliding door opening lower rear where
the lower roller arm mounts in the lower door track.
1. Open hood, disconnect and isolate the battery negative cable.
WARNING: WAIT TWO MINUTES FOR THE SYSTEM RESERVE CAPACITOR TO DISCHARGE BEFORE BEGINNING ANY
AIRBAG COMPONENT SERVICE. PERSONAL INJURY OR DEATH MAY RESULT.
2. Open sliding door to the fullest open position.
