Grand Caravan V6-3.3L VIN R (2005)
12.
Center the heat shrink tubing over the joint and heat using a heat gun. Apply heat to the heat shrink tube until the tubing is tightly sealed and
sealant comes out of both ends of the tubing (Figure 10).
CAUTION:
Use only the sealant lined heat shrink tube provided. Use of electrical tape or non-sealant lined heat shrink may cause circuit failure.
13.
Apply a small amount of dielectric grease (PN J8126688) to the right and left supplemental front airbag sensor harness connector.
NOTE:
Using your finger, force the dielectric grease into the terminal pins of each supplemental front airbag sensor harness connector.
14.
Connect harness connectors to the right and left supplemental front airbag sensors.
15.
For vehicles with the front fascia removed:
a.
Position the front fascia onto the vehicle.
b.
Install the right and left upper fascia bolts and tighten to 50 in. lbs. (5 N.m).
c.
Install the right and left horizontal nuts that fasten the front fascia to the lip of the front fender. Tighten the nuts to 60 in. lbs. (7 N.m).
d.
Install and tighten the two vertical screws that secure the front fascia to the front fenders.
e.
Install the two screws that secure the right and left wheelhouse shield to the front fascia.
f.
Using new push pins if necessary, securing the air dam to the lower radiator crossmember.
g.
For vehicles with fog lamps, connect the electrical harness connectors to the right and left fog lamps.
16.
Lower the vehicle.
17.
Connect the negative battery cable to the battery.
18.
Stand next to the vehicle with the driver's door closed. Reach in through the window opening, going behind the steering wheel, and turn the
ignition key to the "ON" position. Wait 10 seconds:
>
If the airbag warning light is not illuminated, the repair has been completed. Return the vehicle to the customer.
>
If the airbag warning light was illuminated due to a supplemental front airbag sensor fault when the vehicle was brought in for this repair,
continue with Step 19 to clear the sensor DTC.
19.
Turn the ignition key to the "OFF" position and connect the DRBIII to the vehicle.
NOTE:
The DRBIII must be at software Version 64.0 or later.
20.
Turn the ignition key to the "ON" position.
21.
Press the "YES" button when the DRBIII powers up.
22.
Select "DRBIII STANDALONE" and press "ENTER".
23.
Select "1997-2007 DIAGNOSTICS" and press "ENTER".
