Grand Caravan V6-3.3L VIN R (2005)
1. Install the pulley with Installer C-4063 (Fig. 15). Do not use the tool adapters.
2. Ensure that the tool and the pulley remain aligned with the pump shaft. Prevent the pulley from being cocked on the shaft.
3. Install the pulley until it is flush with the end of the power steering pump shaft (Fig. 16).
4. Install the power steering pump on the vehicle.
INSTALLATION
1. Install power steering pump back in vehicle using the reverse order of its removal through the engine compartment of the vehicle.
2. Install the power steering pump on its mounting bracket.
3. Install the 3 front power steering pump mounting bolts (Fig. 11). Tighten the 3 front power steering pump mounting bolts to a torque of 54 Nm (40
ft. lbs.).
NOTE: Before installing power steering pressure hose on power steering pump, inspect the O-ring on the power steering pressure hose for
damage and replace if required.
4. Install the power steering fluid pressure line into the pressure output fitting of the power steering pump (Fig. 10). Do not fully tighten tube nut at
this time.
5. Install the power steering fluid supply hose on the power steering pump supply fitting (Fig. 10). Be sure hose clamp is properly installed.
6. Raise the vehicle.
7. Install the routing clip on the engine for the pressure hose (Fig. 9) and tighten fastener.
8. Install the serpentine drive belt.
9. Install the drive belt splash shield.
10. Lower the vehicle.
11. Tighten the pressure line to pump pressure fitting tube nut to a torque of 31 Nm (275 inch lbs.).
12. Install the wiper module (unit).
13. Connect the negative battery cable on the negative battery post.
