Grand Caravan V6-3.3L VIN R (2005)
NOTE: Before installing the damper on the steering wheel, inspect the damper to ensure the rubber isolator on the damper is not deteriorated or
damaged. If the damper is installed with a damaged isolator, a buzz, squeak or rattle condition may develop.
4. Install the damper on the steering wheel (Fig. 42).
5. Install the steering wheel retaining bolt. Tighten the steering wheel retaining bolt to 61 Nm (45 ft. lbs.) torque.
6. If the steering wheel is equipped with remote audio controls, connect the wiring connector to the clockspring (Fig. 42).
7. Connect the airbag squib wiring connectors to the airbag and the horn and speed control switch connector to the clockspring (Fig. 41).
8. Install the driver airbag in the steering wheel (Fig. 40). Install and tighten the airbag attaching screws to 10 Nm (90 inch lbs.) torque.
9. Connect the battery negative (ground) cable to battery post following special Diagnosis And Testing procedure.
10. Check operation of all steering wheel mounted components.
11. Road test vehicle to ensure proper operation of steering.
