Grand Caravan V6-3.8L (2009)
Integrated Accessory Switch Assembly: Service and Repair
Instrument Cluster Switch Pod - Removal
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable.
2. Remove the center bezel (1) from the instrument panel. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Bezel - Removal.
3. Disconnect the wire harness connector from the back of the instrument panel switch pod (2).
4. Remove the two screws (3) that secure the switch pod to the back of the center bezel.
5. Remove the switch pod from the center bezel.