Grand Caravan V6-3.8L (2009)
Sliding Door Latch: Service and Repair
Hold Open Latch Cable - Installation
INSTALLATION
NOTE: For power sliding door procedures refer to POWER SLIDING DOOR SYSTEM.
1. Match the replacement cable up against the old cable to verify the correct part.
2. Position the hold open latch cable on the door module assembly.
3. Connect the hold open latch cable on the latch assembly. Hook the swedged cable end on the latch link and gently push the cable sleeve retainer in
the latch bracket.
4. Trace the outside handle cable along its routing path and install on its retaining clips and position foam insulators. Use previously made schematic
as a guide or remove the opposite side door trim panel and use that door as a guide.
CAUTION: Be certain replacement cable is routed and retained correctly and foam insulators are properly positioned.
5. Install the door module assembly. See: Service and Repair/Carrier Plate - Installation.
6. Connect the hold open latch cable on the hold open latch assembly. Hook the swedged cable end on the latch link and gently push the cable sleeve
retainer in the latch bracket.
7. Install the appropriate side door trim panel on the vehicle. See: Sliding Door Interior Trim Panel/Service and Repair/Door Trim Panel -
Installation
8. Connect the negative battery cable.