Grand Caravan V6-3.8L (2009)
15. Carefully lift the rear A/C evaporator (2) out of the inboard half of the rear heater-A/C housing (3).
16. Remove the mode-air door (4) and blend-air door (1) from the rear heater-A/C housing. If the foam seal on any air-door is deformed or damaged,
the air door must be replaced.
Front HVAC Housing
ASSEMBLY
NOTE: If the A/C evaporator is being replaced, add 50 milliliters (1.7 fluid ounces) of refrigerant oil to the refrigerant system. Use only
refrigerant oil of the type recommended for the A/C compressor in the vehicle.
NOTE: Make sure that the evaporator drain within the HVAC housing is clean and unrestricted and that the insulator is properly positioned.
NOTE: LHD model shown in illustrations. RHD model similar.
NOTE: If the foam insulator for the A/C evaporator is deformed or damaged, it must be replaced.
1. Install the A/C evaporator (2) into the HVAC housing (3). Make sure that the evaporator drain within the HVAC housing is clean and unrestricted
and that the insulator (1) around the A/C evaporator is properly positioned.