Grand Caravan V6-3.8L (2009)
5. Install the rear blend door actuator (4) and the rear mode door actuator (3) to the rear heater-A/C housing See: Air Door/Air Door Actuator /
Motor/Service and Repair/Blend Door Actuator - Installation and See: Air Door/Air Door Actuator / Motor/Service and Repair/Mode Door
Actuator - Installation.
6. Install the rear blower motor (2) .
7. Install the rear blower motor resistor or power module (1) (depending on application) or See: Control Module HVAC/Service and Repair/Front
Blower Motor Power Module - Installation.
8. Install the rear heater-A/C wire harness (5) onto the rear heater-A/C housing and connect it to the rear blower motor resistor or power module
(depending on application), rear blower motor, rear blend door actuator and the rear mode door actuator. Make sure the harness connector is
properly secured to the side of the rear heater-A/C housing.
9. Install the rear heater core (3) into the end of the rear heater-A/C housing (1). Make sure that the foam seals are properly installed and that the two
retaining tabs (2) are fully engaged.
10. Install the screw (5) that secures the heater core tube bracket (4) to the rear heater-A/C housing. Tighten the screw to 2 Nm (17 in. lbs.).