Grand Caravan V6-3.8L (2009)
1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
2. Release the steering column tilt lever and lower the column to its most downward position for easiest driver airbag removal access.
NOTE: It may be helpful to use a small mirror to aid visibility during the initial attempt to remove the driver airbag from the steering wheel.
3. There are three airbag retainer access holes (1) on the instrument panel side of the steering wheel hub trim cover located at the two o'clock, six
o'clock and ten o'clock positions of the steering wheel. The steering wheel must be rotated to bring each of these access holes up to the twelve
o'clock position of the steering column one at a time for removal.
4. Insert the tip of a short handled, flat-bladed screwdriver (1) into either of the upper (two o'clock or ten o'clock) access holes of the steering wheel
hub trim cover (3) being certain to place the screwdriver blade (2) on the inboard side of the airbag snap retainer wire loop.
