Grand Caravan V6-3.8L (2009)
Washer Fluid Level Switch: Service and Repair
Washer Fluid Level Switch - Installation
INSTALLATION
1. Use a new grommet when installing a new sensor assembly.
2. Assure that the flat of the sensor is aligned under the ridge of the reservoir and that the sensor connector is facing down in the fully seated position.
This will allow for proper operation of the sensor float switch.
3. Connect the electrical body harness connectors to the fluid level sensor. Slide the red lock on the connector to the closed or locked position.
4. Assure that washer hose is properly routed to prevent pinching and possible inoperative washers.
5. Connect the left right front wheelhouse splash shield and move aside See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and
Repair/Splash Shield - Installation.
6. Install the right front wheel and tire assembly See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement/Tires and
Wheels - Installation.
7. Lower vehicle from hoist or jack stands.
8. Connect the battery negative cable.
9. Verify system operation.
