Grand Caravan V6-4.0L (2008)
Trunk / Liftgate Motor: Service and Repair
Power Liftgate Drive Unit - Installation
INSTALLATION
1. Install the power liftgate drive unit assembly (3) onto the D-pillar (2).
2. Insure that the drive unit bracket mounting tab is properly seated into the hole on the D-Pillar (1).
3. Install the drive unit retaining bolts (4). Tighten the bolts to 26 Nm (19 ft. lbs.).
4. Connect the wire harness connector to the drive unit assembly.
5. If equipped, install the subwoofer,See: Accessories and Optional Equipment/Radio, Stereo, and Compact Disc/Speaker/Service and
Repair/Speaker - Installation.
6. Install the left quarter trim panel (5).
a. Position the left quarter trim panel (5) into the vehicle.
b. Connect the auxiliary power outlet and power inverter (2) wire harness connectors (3) (if equipped).
c. Align the trim panel over the retaining slots on the inner quarter panel (1) and firmly snap into place.
d. Install the six quarter trim retaining screws.
e. Install the third row upper turning loop anchor bolt.
f.
Install the third row lower seat belt webbing anchor (4).
7. Install the quarter trim bolster (5).
a. Position the quarter trim bolster (5) into the vehicle and slide the rear seat belt (3) into the slot.
b. Align the locating tabs (4) with the holes in the left quarter trim panel.
c. Carefully engage the quarter trim bolster upper retaining tabs (2) by inserting them into the left quarter trim panel and swinging the bottom
edge of the bolster towards the left quarter trim.
