Grand Caravan V6-40L (2008) Seat Heater Switch Service and Repair
NOTE: Right sliding door shown, left sliding door similar.
1. Assemble the rear heated switch (3) into the switch bezel (4) by pressing the two together until the retaining tabs snap securely into place. Make
sure that the switch retaining tabs are fully engaged to the bezel.
2. Connect the wire harness connector (5).
3. Install the switch and bezel assembly into the sliding door trim panel (6). Press the switch into the trim panel opening until the retaining tabs snap
securely into place. Make sure that the switch bezel retaining tabs are fully engaged to the door trim panel.
4. Connect the battery negative cable.
5. Verify 2nd row heated seat system operation.