Grand Caravan V6-4.0L (2008)
NOTE: While bleeding air from the brake caliper in the following steps, be sure to monitor the fluid level in the master cylinder reservoir
making sure it does not go dry.
14. Have a helper pump the brake pedal three or four times and hold it in the down position.
15. With the pedal in the down position, open the bleeder screw at least one full turn and let out fluid and air, if any.
16. Once the brake pedal has dropped, close the bleeder screw. Once the bleeder screw is closed, release the brake pedal.
17. Repeat the previous three steps as necessary until all trapped air is removed.
18. If necessary, bleed remaining wheel circuits as necessary using normal bleeding procedure.See: Brake Bleeding
CAUTION: When removing or installing a caliper guide pin bolt, it is necessary to hold the guide pin stationary while turning the bolt. Hold
the guide pin stationary using a wrench placed upon the pin's hex-shaped head.
19. Tighten both guide pin bolts to 35 Nm (26 ft. lbs.).
20. Pull the parking brake cable strand (1) outward from the cable housing and hook it onto the caliper lever (2).
21. Push the excess cable strand back into the cable housing, then insert the cable housing (3) into the mounting bracket (1) until the retainer fingers
(2) lock into place. Make sure both fingers are engaged preventing removal of the cable from the bracket.
22. Reconnect the parking brake cable equalizer and reset the automatic self-adjusting mechanism tension of the parking brake lever assembly.See:
Parking Brake System/Service and Repair
