Grand Caravan AWD V6-3.8L VIN L (2001)
Camshaft Position Sensor: Service and Repair
REMOVAL
1. Disconnect the negative battery cable.
Fig.6 Air Box Cover
2. Remove the air box cover and inlet tube.
Fig.7 Camshaft Position Sensor
3. Disconnect camshaft position sensor electrical connector from the wiring harness connector.
4. Remove bolt holding sensor.
5. Rotate sensor away from block.
6. Pull sensor up out of the chain case cover. Do not pull on the sensor lead. There is an O-ring on the sensor case. The O-ring may make removal
difficult. A light tap to top of sensor prior to removal may reduce force needed for removal.